AGA ATC3WHT Przewodnik Instalacji

InstallationGuide09/13 EINS 516294PLEASE READ THESE INSTRUCTIONS BEFORE COMMENCING SITE SURVEYOR INSTALLING THIS APPLIANCE.IMPORTANT : SAVE INSTRUCTIO

MAINS SUPPLY LOCATION - AGA TC3Fig. 4 DESN 516295THE MAINS SUPPLY CONNECTION AND ISOLATION POINT MUST BE WITHINTHE ZONE SHOWN10RATING LABEL LOCATEDBEH

MAINS SUPPLY LOCATION - AGA TC5 Fig. 5 DESN 516562MAINS CABLE FED FROM CONTROLTRAY LEFT OR RIGHT EXITTHROUGH DUCTING DEPENDENTUPON POSITION OF SUPPLYS

HOTCUPBOARD INSTALLATIONNOTE: The AGA TC5 hotcupboard should arrive with the top plate in a jacked up position. Thisis to allow the complete appliance

2. Position the plinth alongside the AGA Total Control leaving no gap between the two plinths (See Fig. 8).Check with a spirit level that the plinth l

4. Run a straight edge along the front of the AGA Total Control plinth, to ensure the front face ofboth plinths sit squarely against the straight edge

Fig. 12 DESN 5165526. Slide hotcupboard onto plinth until rear tongue bracket engages fully into rear of base slot, (See Fig. 12). Ensure the applianc

8. Using the stay rod nut adjusting tool, carefully lower the top plate adjusting nuts until the topplate sits at the required height, making sure tha

17HANDRAIL CONNECTION - AGA TC3Fig. 16 DESN 516560Handrail brackets. endcaps and handrails require assembly.Locate endcaps onto handrail, place bracke

18Fig. 17MAINS CORD AND WIRING DIAGRAM - AGA TC3

19Fig. 18WIRING DIAGRAM - AGA TC5 (HOTCUPBOARD OPTION)COLOUR KEYS/COLLEURSBR - BROWN/MARRONBL - BLUE/BLEUGR - GREEN/VERTOR - ORANGE/ORANGEBK - BLACK/N

SECTION PAGEGENERAL NOTES 3DELIVERY REQUIREMENTS 3GENERAL INSTALLATION REQUIREMENTS 3APPLIANCE DIMENSIONS - AGA TC3 4APPLIANCE DIMENSIONS - AGA TC5 5I

20INSTRUCTIONSAttach warning hanger (EGLL516660) located in literature pack, to AGA Total Control handrailwhen installation is complete. Advise custom

21

22

23

24For further advice or information contactyour local AGA SpecialistWith AGA’s policy of continuous productimprovement, the Company reserves the right

GENERAL NOTES3NOTE: THESE INSTALLATION INSTRUCTIONS SHOULD BE LEFT WITH THE APPLIANCEAND THE USER TO RETAIN FOR FUTURE REFERENCE.Before installation o

4APPLIANCE DIMENSIONS - AGA TC3Fig. 1 DESN 516297Cooker DimensionsWhen surveying for a cooker installation the actual clearance required for the ‘body

APPLIANCE DIMENSIONS - AGA TC5 5Fig. 2 DESN 516561Cooker DimensionsWhen surveying for a cooker installation the actual clearance required for the ‘bod

6INSTALLATIONRange Base or HearthIt is essential that the base or hearth on which the range stands should be level and be capableof supporting the tot

7NOTE: ANY OVERHEAD FITTEDCABINETS MUST NOT EXCEED 13”PROJECTED DEPTH ABOVE THERANGE.DIM ‘D’ TO BE NOT LESS THAN THENORMAL WIDTH OF THEAPPLIANCE.Fig.

CONNECTION TO THE POWER SUPPLY - AGA TC3Electric Shock HazardRating Plate is located behind removable plinth, see Fig. 4.Electrical Grounding is requi

POWER SUPPLY - HOTCUPBOARD (AGA TC5)The hotcupboard attachment requires an independent single phase supply. It has amaximum load of 6 amps, protected