AGA EC3 Instrukcja Obsługi

03/08 EINS 515269PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING THIS APPLIANCEREMEMBER: when replacing a part on this appliance, use only spare part

OVEN THERMOCOUPLEFig. 7 DESN 515277NOTE: On AIMS controlled cookers the thermostat phial (probe) hasbeen replaced by an oven thermocouple sensor, whic

11OVEN VENTING SYSTEMSSee Figs. 9, 10, 11 & 12Pre-site visiting will have determined where and how the layout of the oven vent pipework shouldbe d

12Fig. 10Fig. 11Fig. 12DESN 515278 DESN 513938DESN 515431

Handset can be wall mounted as described below.- Remove backplate from the rear of the Handset by sliding down with hand and away from the Handset (fi

Hand these instructions to the User for retention, and instruct in the safe operation of theappliance.Finally advise the User, that for continued effi

15

16For further advice or information contactyour local Aga SpecialistWith Aga’s policy of continuous productimprovement, the Company reserves the right

SECTION PAGECONSUMER PROTECTION 3HEALTH & SAFETY 3INSTALLATION 4TECHNICAL DATA - AGA EC3 5BAKING OVEN BAFFLE PLATE 6ELECTRICAL 6ELECTRICAL TEST PR

Consumer ProtectionAs responsible manufacturers we take care to make sure that our products are designed andconstructed to meet the required safety st

With specific exceptions, the installing of any type of Aga cooker is subject to the respectivedirections contained in current issue of the Building R

5TECHNICAL DATA - AGA EC3Fig. 1 DESN 514194ABCDFGHKLMNRTmm987889 851 67913307561125 3698 484 816 116 52* THIS HOLE IF REQUIRED FOR OVEN VENT PIPE IS T

WARNING: THIS APPLIANCE MUST BE EARTHED.THIS APPLIANCE IS DESIGNED FOR THE VOLTAGE STATED ON THE RATING PLATE,WHICH IS SITUATED BEHIND THE UPPER LEFT

7Fig. 2TO TEST THE AIMS CONTROL HANDSETPress the fan button on the handset, the vent fan symbol should show on the handset screen.The oven vent fan sh

MAINS CABLE AND GUIDE TUBE ASSEMBLYFig. 4 DESN 514243 A/ DESN 5146268

9OVEN VENT PIPE CONNECTION OPTIONSELEMENTS AND ELECTRICAL HOUSING PARTS ASSEMBLYFig. 6 DESN 514205 AFig. 5 DESN 514245